It's bad enough that I have to clean two sensors, but when I cannot the screws off even one side, it's frustrating! I can only remove one screw from each side and for the life of me cannot get the other screws off.they are starting to strip on the on inside. There are two screws on each sensor (and two sensors). Low speed/RPM's are just fine so figured that the sensors are not doing their job. The RPM's didn't move then shot to 5-6K with about a 5km acceleration. I would depress the gas and it would not respond. I noted on the road that I could not accelerate in the typical nfiniti fashion. This morning the Malfunction Light flashed back on again. As I had no issues with fuel economy, starting stopping, accelerating, I reset the code and continued on my way ( I drive <200km a month and figured I could clean this when it was not as cold outside). I read online that K&N air filters may cause the sensors to accumulate dust/debris and figure that's probably the reason. Ok, no biggie, could be as simple as a sensor cleaning. Last weekend I got the dreaded "Malfunction Indicator" Ran the code ( P0101) which indicates an issue with the Mass Air Flow Sensor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |